If possible stain all sides of the siding before installation.
Best way to get paint off of cedar shingle siding.
Painted shingles look great for the first two to three coats of paint.
The best way to remove paint from lap board siding.
Shingle siding house with massive paint failure.
Has anyone run into a similar situation.
I usually rely on a paint shaver for step 3 which will not work on rough cedar shakes.
Certain areas are peeling and lifting and the color has faded.
With a porous material like cedar the main idea is to apply a greater quantity of paint to the wood and hand brushing is the best way to accomplish this.
Cedar is commonly used for outdoor furniture roofing and for shingles on the outside of a home.
Cedar is a soft wood and the force of a power washer while it will take the paint off easily enough will also very likely damage the wood and drive moisture deep into it causing your future paint job to peel off later.
Cracked or peeling paint can occur on cedar siding for a number of reasons according to william feist of the western red cedar lumber association.
Staining cedar siding differs from application of paint and other finishes.
3 scrape sand to remove any loose paint and feather the edges.
Stains dry rapidly and fresh stain applied over dried stain will show lap marks.
I see that wagner makes a tool called the paint eater that uses a small 3m abrasive disk and was wondering if this is a possible solution.
But if your home is sided in traditional cedar shingles you re stuck doing it the old fashioned way.
When the wood goes through a series of wet dry periods the paint and finish are stressed and the paint can crack.
The key to a successful application of paint is surface preparation.
After years of being painted exposed to the elements and painted again the paint on cedar will begin to crack and peel.
If one chooses to spray the paint on the cedar the best results will be achieved by back brushing the finish during application.
First remove any mill glaze a hard shiny surface on one side of the siding by sanding.
If the stripping compound has enough time to finish its work it.
For refinishing especially hand brushing is always preferred.
Begin scraping off the mixture of paste and paint using the paint scraper.